Type KR2500 cantilever rack
-
Fest verschweißte Arme -
Einfache & schnelle Montage

Type KR2500 Top seller
Type KR2500 cantilever rack
A complete upright consists of a blue upright profile, a welded-on foot section and 5 welded-on cantilevers. A rack upright has a height of 2m.
The individual uprights are connected to each other using the cross and diagonal struts. The distance between two uprights is called axial dimension.

Easy to assemble
Best price
All parts included
Assembly instructions
The quality of our products
Voluntary inspection of our cantilever racks
We voluntarily submit our products to external quality control on an annual basis.
The shelves are tested for load, rigidity and stability.
The maximum compartment and unit loads are listed on the load labels included in the delivery volume.
Types
Painted for indoor use
Technical information
Fixing to the floor
Required parts:
Assembled shelf, bolt anchor
- Drill holes: 10mm ∅, 100mm deep
- Blow holes clean
- Insert the anchor into the floor bracket – nut should be flush with thread
- Tighten anchor firmly
- After tightening, the marking on the thread must not be visible!
Please note:
The bolt anchors must be properly fastened.
If necessary, commission a specialist company!
Axial dimensions
The axial dimension describes the width of a shelf unit as well as the distance between two uprights
Technical information
Assembly of cross and diagonal struts
Required parts:
Uprights, cross strut, hexagon screw, hexagon nut
First the cross struts are attached to the top and bottom of the uprights. When doing so please note that the inside of the struts point in the direction of the cantilevers and that the struts are open to each other, with the lower strut opening upwards.
Required parts:
Diagonal struts, hexagon screw, hexagon nut
Now the diagonal struts can be attached to the cross struts forming a cross. The diagonal struts are attached to the outside of the cross strut. First the screw connections are tightened by hand. When the rack is in position, the screws are tightened firmly.
Diagonal struts + cross struts are used to reinforce the section between the uprights and increase stability